How to make a fingerboard: written

THIS IS WRITTEN FOR BEGINNERS!

1. Get veneers *maple, ash, cherry...etc.
2. Get a mold, Make out of bondo, techdecks, or Risen.
3. Get Wood glue
4. Get a vice or clamps **Vice for bondo or risen and Clamps for techdeck


Cut your veneers accordingly
1. Cut 2 length wise
2. Cut 3 width wise
or vise versa

Glue them by:
1.Putting a sting of glue on the first one, then rub with fingers till glue is spread equally
2. Do this for the rest

SETUP:
1. after they;re put together line them up perfectly
2. put them in your mold
3. CLAMP or VICE them
4. wait


FINISHING:
1. take it out, trace on it
2. Cut it out
3. SAND AROUND THE EDGES AND ANY PARTS THAT ARE YUCKY
5. Drill holes with techdeck as template
6. laquer